HIGH PRESSURE- RESISTANT POLYETHYLENE PIPES WORKING IN THE RELEASE ADD-ON ADDITIONS

Authors

  • Yulduz Xidirova Professor at Karshi State Technical University
  • Hulkar Husanova Master’s student at Karshi State Technical University

Keywords:

polyethylene pipe, additives, dosage system, extrusion, asterbatch, automation.

Abstract

This scientific in the article polyethylene pipes working release in the process additions​ add system efficiency increase issues wide illuminated. Additions​ types, their polymer to the mass effect, dosage accuracy importance and modern automated from systems use through working release quality improve roads analysis done. Obtained results high good quality and competitive polyethylene pipes working in the release important scientific and practical importance.

 

References

Gulomov SG. , Khudoyberdiev AA Polymer materials technology. – Tashkent, 2018.

Abdurakhmonov RA Polymer and composite materials. – Tashkent, 2019.

Ochilov BM Plastics again work technology. – Tashkent, 2017.

Rauwendaal C. Polymer Extrusion. – Hanser Publishers, 2018.

Ebnesajjad S. Additives for Plastics Handbook. – Elsevier, 2020.

Rosato DV, Rosato MG Plastics Processing Data Handbook. – Springer, 2019.

ISO 4427. Plastics piping systems – Polyethylene (PE).

Downloads

Published

2026-02-09

How to Cite

Yulduz Xidirova, & Hulkar Husanova. (2026). HIGH PRESSURE- RESISTANT POLYETHYLENE PIPES WORKING IN THE RELEASE ADD-ON ADDITIONS. Ethiopian International Journal of Multidisciplinary Research, 13(2), 486–487. Retrieved from https://www.eijmr.org/index.php/eijmr/article/view/5050

Issue

Vol. 13 No. 2 (2026): Ethiopian International Journal of Multidisciplinary Research

Section

Articles